Agilent Technologies XY Operator's Manual page 22

Figure 7
tubing fitting
needle holder bracket and screw
needle retaining screw
needle holder
needle
needle foot
needle guide
1 Place the metal lock washer onto the needle guide.
2 Screw the needle guide with lock washer into place on the bottom side of the
Installation
Assembling the XY Autosampler
Needle Installation
Locate the accessory packages containing the needle (part number
G1811-23200) and the needle holder/guidekit.
When installing the needle, refer to Figure 7 that shows where the needle,
needle holder, and needle guide are installed on the XY autosampler.
Installing the Needle
Installing Needle Guide
To install the needle guide:
needle foot.
22