Table of Contents
Advertisement
UPS5000-A-400 kVA
User Manual (60 kVA, PF=0.9)
Figure 3-4 Hole dimensions (unit: mm)
Step 2 Drill holes and install expansion sleeves.
1.
2.
3.
4.
Figure 3-5 Drilling a hole and installing an expansion sleeve
(1) M12 bolt
(4) Expansion sleeve
Issue 05 (2019-12-24)
Drill a hole in the concrete floor using a hammer drill. The hole depth should range from
52 mm to 60 mm.
Slightly tighten the expansion bolt and vertically insert it into the hole. Knock the
expansion bolt using a rubber mallet until the expansion sleeve is fully inserted into the
hole.
Partially tighten the expansion bolt.
Remove the bolt, spring washer, and flat washer.
Copyright © Huawei Technologies Co., Ltd.
(2) Spring washer
(5) Expansion nut
3 Installation
(3) Flat washer
(6) Concrete floor
44
Advertisement
Table of Contents
