Table of Contents
Advertisement
ASSEMBLY
Bridge Hitch Installation
PFT Series
Bring the rear of the Bridge Hitch into position between the frame hitch plates at the center of the frame. Place two
1-1/4 Washers on each side between the Bridge Hitch and the Hitch Plates. Line up the holes and insert 1-1/4-7 x
10-1/2 Bolt, secure with Locknut. The locknut should be tightened so that the frame is free to pivot on the Bridge Hitch.
See Figure 2-2.
Figure 2-2: PFT Series Installation
PT Series
Bring the rear of the Bridge Hitch into position between the frame hitch plates at the center of the frame. Place one
1-1/4 x 1-7/8 Machinery Bushing on each side between the Bridge Hitch and the Hitch Plates. Line up the holes and
insert 1-1/4 x 10 Pin, insert two 1/4 x 2 Cotter Pins and spread them. See Figure 2-3
Figure 2-3: PT Series Installation
2-3
Advertisement
Table of Contents
