Table of Contents
Advertisement
NOTE
This chapter will cover the basic operation and
procedures for the Landoll Brillion Bridge Hitch. Be sure
to read and understand the Safety Procedures and
Cautions starting on page 1-2.
Before operating your Brillion machine check all
hardware for tightness. Use the Torque Tightening Chart
as a guide. See page 4-1.
Escaping hydraulic fluid can cause serious
personal injury. Relieve system pressure before
repairing, adjusting, or disconnecting. Wear
proper hand and eye protection when searching
for leaks. Use cardboard instead of hands. Keep
all components (cylinders, hoses, fittings, etc.) in
good repair
IMPORTANT
It is the responsibility of the owner/operator to
comply with all applicable laws regarding slow
moving vehicle signs, warning lights and reflectors.
NOTE
Prevent wheel breakage by reducing speed when
operating in rocky conditions.
WARNING
Figure 3-1: Transport Lock
Maximum road speed is 20 MPH under good
conditions. Do not tow the machine at a speed
which makes vehicle control difficult.
Do not stand between the two pieces of
equipment when attaching to the drawbar unless
they are not moving.
Transporting on Roadways
To prepare the machine for transport, raise the Transport
Pulverizer or Floating Ring Pulverizer completely.
Remove Transport Lock from the left side of the Bridge
Hitch. Place the Transport Lock over the cylinder rod.
Secure in place by inserting Bent Pin and Hair Pin. See
Figure 3-1.
Field Operation
Once the machine has been transported to the field,
remove the Transport Lock from the cylinder rod. Place
the Transport Lock on the storage channel located on the
left side of the Bridge Hitch. Secure in place by inserting
Bent Pin and Hair Pin. See Figure 3-1.
Chapter 3
Operation
WARNING
CAUTION
3-1
Advertisement
Table of Contents
