Table of Contents
Advertisement
ASSEMBLY
Gooseneck Coupler Installation
At the front of the Bridge Hitch slide the Gooseneck
Coupler up into the Gooseneck tube, align the top hole
and insert the Bent Pin, secure with Hair Pin Cotter.
Thread a 3/4-10 Nut halfway onto each 3/4-10 x 2 Bolt.
Screw them into the 3/4-10 welded nuts on the
Gooseneck tube. Snug the Bolts up against the
Gooseneck Coupler, turn the 3/4-10 Nuts so they are
tight against the welded 3/4-10 Nuts. See Figure 2-1.
2-2
Figure 2-1: Gooseneck Coupler Installation
Attach the Safety Chain to the Bridge Hitch by sliding
three 1 inch Washers into the slotted end of the chain,
place two 1 inch Washers between the chain and the
Bridge Hitch. Insert 1-8 x 9-1/2 Bolt through the chain,
washers and hitch, secure with 1-8 Locknut.
Install the Double Stand into the rear of the Bridge Hitch
be sliding it up into the stand tubes, secure with two 3/4
Pins with Chains.
Mount the Manual Storage Canister to the right side rear
of the hitch using two Hose Clamps.
F-778
Advertisement
Table of Contents
