Clear Cmos Jumper; Table 5-2: Clear Cmos Jumper Settings - IEI Technology PCIE-9450 User Manual

PCIE-9450 PICMG 1.3 CPU Card

5.4.1 Clear CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
If the PCIE-9450 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the "CMOS Settings Wrong" message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-2.
AT Power Select
Short 1 - 2
Short 2 – 3

Table 5-2: Clear CMOS Jumper Settings

The location of the clear CMOS jumper is shown in Figure 5-9 below.
JP1
3-pin header
See Table 5-2
See Figure 5-9
Description
Keep CMOS Setup Default
Clear CMOS Setup
Page 71