Nfc Tap And Write Device Settings Using Stat Configurator App - Delta enteliZONE eZNT-Wi Series Application Manual

Before configuring an enteliZONE product, ensure NFC is enabled and that the sound
is turned up on your NFC equipped phone or tablet.
1) Move the NFC device antenna over the front of the target enteliZONE device. The
NFC antenna is located at the bottom of the front plate to the left of the Delta Logo.
The NFC phone/tablet antenna location varies by model, but is typically located near
the logo on the back of the device. Consult the documentation for your Android
device.
2) Listen to the sound from your phone or tablet as you move the NFC device over
the thermostat.
If necessary, adjust the sound level on your NFC equipped phone or tablet.
3) Hold the NFC device over the device until the following message displays on the
screen: Successful Configuration Read.
You may initially see this message: Error: Failed read. Please hold device steady
over target NFC device.
4) Touch the password field and then type in a Device Password. The default is 1011.
Then, tap the ENTER button.
AV531 contains the NFC Password.
To work with the onscreen configuration menu, this password must contain
only 1 or 0 digits.

NFC Tap and Write Device Settings Using Stat Configurator App

A typical approach is to duplicate existing settings from one enteliZONE product to
others. First, NFC tap the device and then enter the device password. Next, read the
configuration data from an initial device, modify the configuration settings once, set
the device address, and then tap in and transfer the settings to an enteliZONE
device. For the next device, change the device address and then transfer the
settings to this next device. Repeat this process. An enteliZONE device does not
need to be powered up and can be inside its shipping box.
First, do an NFC tap on the enteliZONE device using the procedure provided in the
previous NFC Tap and Read the Configuration Data
1) NFC tap the device with the Stat Configurator app. The following message
displays on the screen: Successful Configuration Read.
2) Touch the password field and then type in a Device Password. The default is 1011.
Then, tap the ENTER button.
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4
topic.
Page 95 of 126