Table of Contents
Advertisement
On-Screen Menu Configuration
On-Screen Menu Configuration
The enteliZONE thermostat products offer means to navigate menus and display
values using the on-screen menu. When you enter the password, you can navigate
and modify configuration settings.
When a new eZNT-Wi or eZNTW/eZNTW-Wi is powered ON, it is in the default
manufactured state and briefly displays the firmware version, firmware build
number and the SSID on the screen. For example, on powerup the following values
might display: 340 (firmware version), 425 (firmware build number, first 3 of 6
digits) and 238A. The SSID 238A consists of the last four HEX digits of the AP Mode
MAC address. See the three Installation and Configuration Guides on the
eZNT-Wi
TS support page
for information on the setup required for the eZNT-Wi-T100, eZNT-
Wi-T331 or eZNT-Wi-T304 hardware.
For an eZNT-Wi or eZNTW-Wi with 3.x firmware (Build 428051+), the display now
show RSSI signal strength information to help troubleshoot Wi-Fi connections during
setup. When a device is connected to an wireless network, the default display shows
the current temperature reading in degC on line2 and the RSSI signal strength
shows on the bottom line (line3). To display temperature in degF units, set the
Object Sensor Type field in AI1. The line3 display area can show four characters and
does not include a dB unit after the RSSI value. If the device is not connected to a
Wi-Fi network, then a value of 0 is shown in the line3 area. If a GCL program is
writing to the LCD0 line2 or line3 display property, the default screen is cleared. For
more information, see the AV94 (WiFi_RSSI) entry in the Object Instances Numbers
table in the
Database Objects
section.
Many of the settings can also be modified through the on-screen menu available on
each unit. Often, the quickest method to configure an enteliZONE thermostat is to
use the NFC Net Builder and/or the Stat Configurator apps. The NetBuilder app
focuses on the settings to get a thermostat addressed and running on the network
while the StatConfigurator focuses on thermostat settings such as button layout,
touch sensitivity and display backlight color. Refer to II: Wi-Fi Configuration: NFC –
Net Builder topic in the
Workflow: Do Wi-Fi Setup
section.
A: Configuration Menu Access
Access to the Configuration Menu is protected by an access code or PIN. You must
enter the valid PIN before access is granted. You can activate the Configuration
menu by pressing and holding touch area 8 and then pressing and holding touch area
4 until PIN appears on the display. From the Configuration Menu, enter the four digit
PIN code (default=1011). The following procedure provides detailed steps.
Page 52 of 126
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4
Hide quick links:
Advertisement
Table of Contents
