Delta enteliZONE eZNT-Wi Series Application Manual page 25

4. Press touch area 8 to select Yes. The changes are saved and the unit exits the on
screen configuration menu.
To change the AP Host Mode
1. Log into the Configuration Menu. If needed, see the previous To log into On-
Screen Configuration Menu procedure.
2. Press touch area 4 to move through the menu options.
3. Stop when AP appears on the display.
4. Press touch area 8 to toggle the current value (e.g. from off to on).
5. Save the changes. See the previous
You can change the status of many parameters using the touch pad. For example,
you can navigate to the Micro USB port parameter and then enable or disable it by
pressing touch area 8. Save the changes. If needed, see the procedure: To save
configuration changes.
When you disable the USB port, the device also disables the webserver.
To check the Station Client Mode Status
1. Log into the Configuration Menu. If needed, see the previous
Screen Configuration Menu
2. Press touch area 4 to move through the menu options.
3. Stop when rOU appears on the display. The current state displays at the bottom
of the display (e.g. oFF or CON for connected). The Wi-Fi signal strength is indicated
by wave bars on the display screen. Five bars represent maximum signal strength.
To view the SSID address of an eZNT-Wi/ eZNTW
1. Log into the Configuration Menu. If needed, see the previous
Screen Configuration Menu
2. Press touch area 4 to move through the menu options.
3. Stop when Sid appears on the display. The Sid parameter contains the SSID and
identifies the particular device when making a Wi-Fi connection. For example, eZNT-
447E / eZNTW-238A or similar router name (SSID) might appear in the list of
possible Wi-Fi connections. These are the last four HEX digits of the AP Mode MAC
address.
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4
To save configuration changes
procedure. [Link]
procedure.
procedure.
To log into On-
To log into On-
Page 25 of 126