Delta enteliZONE eZNT-Wi Series Application Manual page 50

Troubleshooting Wi-Fi
Issue
Configuration webpage 192.168.124.1
Changes do not take
effect.
Configuration
webpage does not
accept Keypad
Password in Device
Info section of the
page.
Not get configuration
webpage for specific
Wi-Fi thermostat.
enteliWEB
Cannot see any eZNT-
Wi/ eZNTW units
during initial AP (Host)
mode.
Time Wi-Fi thermostat
Issues with time loss
during resets, backup
operations, power
outages, watchdog
timer resets.
Cannot load a GWT
.pob file.
Page 50 of 126
Action / Expected Result / Comment
Click the Save button located in the top right of the
Configuration page.
Ensure that more than one device is not connected at a
time.
Confirm that the correct password was entered. It is
possible that the password was changed from the
default value.
For the Keypad PIN, each digit must be either 0 or 1.
The AV531 object for each thermostat contains the
password. The password cannot be changed in the
webpage.
Verify that you do not have an active internet
connection. If doing internal setup, make sure that
there is no unintended external connection or you may
NOT get the Configuration webpage for a specific Wi-Fi
thermostat.
Connect under Station Mode IP.
In Station mode, the Wi-Fi thermostat are visible in
enteliWEB. You could use the Configuration webpage
as it connects to an eZNT-Wi/ eZNTW directly, via AP
mode.
Confirm that a unit has USB mode is enabled. If the
USB is disabled, the webpage is not visible. By default,
the USB mode is enabled.
Select the Wi-Fi thermostat in enteliWEB and execute
the Set Time command. See also the enteliZONE
Thermostat Time synchronization section.
See KbA-1748 for best practices for time synch. It
includes information relating directly to the Wi-Fi ther-
mostat products.
Be sure to use enteliZONE GWT objects and not the
older DAC GWT objects.
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4