Gcl For Simple Slider Control Of A Setpoint - Delta enteliZONE eZNT-Wi Series Application Manual

Advanced Control (AV518=0)
When in advanced control, the slider is read in a similar manner to the buttons but
through the Keypress property. The value provided to GCL gives an indication of the
initial finger position and the final finger position. These values are not sent to the
application controller until the finger is released. Using advanced control allows for
further flexibility when it comes to interpreting how the slider works.
The slider changes are represented in a higher range of values in the Keypress
property, 10000-19999. The first digit represents the slider (1), the next two digits
represent the start position (00-99) and the last two digits represent the end
position (00-99). For example, pressing and dragging from 30% to 70% gives a
keypress value of 13070. Pressing and dragging from 70% to 30% gives a keypress
value of 17030.

GCL for Simple Slider Control of a Setpoint

The following code segment shows how to adjust a setpoint using the slider for
eZNT, eZNT-Wi and eZNTW products.
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4
Page 85 of 126