Define A Wi-Fi Configuration And Device Settings Using Net Builder App - Delta enteliZONE eZNT-Wi Series Application Manual

Define a Wi-Fi Configuration and Device Settings Using Net Builder App

See Appendix: enteliZONE Thermostat Setup Using an Android NFC App
information on App Preview mode and also details on how to do an NFC Tap on an
enteliZONE thermostat using an NFC app.
The Net Builder App focuses on setting the network settings for Wi-Fi UDP/IP, and
Linknet or MS/TP as needed and also specifies the device address. The thermostat
does not need power for the NFC feature to work. You can tap into a thermostat that
is still in its individual shipping box.
A typical approach is to read the configuration data from an initial NFC thermostat,
modify the network configuration once, set the device address, and then tap in and
transfer the settings to another device. For the next unit, change the device address
and then transfer the settings to this device. Repeat this process.
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4
for
Page 27 of 126