Linknet Setup For Eznt-Wi And Ezntw-Wi - Delta enteliZONE eZNT-Wi Series Application Manual

Workflow: Do Wi-Fi Setup
4. In the Command field, select Commit.
5. Click Save. A green checkmark indicates a connection while a red exclamation
mark indicates a failed connection attempt.
If needed, see the Troubleshooting Wi-Fi

Linknet Setup for eZNT-Wi and eZNTW-Wi

With Host AP mode active, enter 192.168.124.1 into a browser. When the web page
for the specific eZNT-Wi/ eZNTW-Wi appears, enter in the username/ password.
The default username is ADMIN and the default password is ADMIN. The
configuration webpage for the selected wireless thermostat appears. Go to the
BACnet Network Setting section of the webpage. The setting in BACnet Network
Settings section actually relate to Linknet configuration despite the section name.
The eZNT-Wi/ eZNTW-Wi can support four Linknet devices with a maximum of two
DFM-4xx devices. DFM-16xx devices are not supported.
See the eZNT-Wi/ eZNTW Installation Guides for more information.
https://support.deltacontrols.com/Products/EzntWi
To set up Linknet I/O communications on a Wi-Fi thermostat:
1. From an eZNT-WI/ eZNTW-Wi, connect the thermostat NET1 wiring to the
NET1 port of the DFM 4xx/eZNS/DNS.
2. Confirm communication between each thermostat NET1 and the DFM-
4xx/eZNS/DNS.
Page 46 of 126
section.
eZNT-Wi Programmable Wi-Fi Thermostat Application Guide
Edition 1.4