Acl - ORiNG RGS-R9004GP+ME-HV User Manual

IP Address
MAC Address
5.8.4

ACL

Ports
This page allows you to configure the ACL parameters (ACE) of each switch port. These
parameters will affect frames received on a port unless the frame matches a specific ACE.
Label
Port
Policy ID
Action
Rate Limiter ID
Port Redirect
Mirror
Logging
Shutdown
ORing Industrial Networking Corp
Allowed source IP address.
Allowed source MAC address.
Description
The switch port number to which the following settings will be applied
Select to apply a policy to the port. The allowed values are 1 to 8.
The default value is 1.
Select to Permit to permit or Deny to deny forwarding. The default
value is Permit.
Select a rate limiter for the port. The allowed values are Disabled or
numbers from 1 to 15. The default value is Disabled.
Indicates the port redirect operation implemented by the ACE.
Frames matching the ACE are redirected to the listed port.
Select which port frames are copied to. The allowed values are
Disabled or a specific port number. The default value is Disabled.
Specifies the logging operation of the port. The allowed values are:
Enabled: frames received on the port are stored in the system log
Disabled: frames received on the port are not logged
The default value is Disabled. Please note that system log memory
capacity and logging rate is limited.
Specifies the shutdown operation of this port. The allowed values
RGS-R9004GP+ME User Manual
159