Snmp User Configurations - ORiNG RGS-R9004GP+ME-HV User Manual

Label
Delete
Community
Source IP
Source Mask
5.5.4

SNMP User Configurations

This page allows you to configure SNMPv3 user table. The entry index keys are Engine ID
and User Name.
Label
Delete
Engine ID
User Name
Security Level
ORing Industrial Networking Corp
Description
Check to delete the entry. It will be deleted during the next save.
Indicates the community access string to permit access to
SNMPv3 agent. The allowed string length is 1 to 32, and only
ASCII characters from 33 to 126 are allowed.
Indicates the SNMP source address
Indicates the SNMP source address mask
Description
Check to delete the entry. It will be deleted during the next save.
An octet string identifying the engine ID that this entry should
belong to. The string must contain an even number between 10
and 64 hexadecimal digits, but all-zeros and all-'F's are not
allowed. The SNMPv3 architecture uses User-based Security
Model (USM) for message security and View-based Access
Control Model (VACM) for access control. For the USM entry,
the usmUserEngineID and usmUserName are the entry keys.
In a simple agent, usmUserEngineID is always that agent's own
snmpEngineID value. The value can also take the value of the
snmpEngineID of a remote SNMP engine with which this user
can communicate. In other words, if user engine ID is the same
as system engine ID, then it is local user; otherwise it's remote
user.
A string identifying the user name that this entry should belong
to. The allowed string length is 1 to 32, and only ASCII
characters from 33 to 126 are allowed.
Indicates the security model that this entry should belong to.
Possible security models include:
RGS-R9004GP+ME User Manual
107