Port Policing; Queue Policing - ORiNG RGS-R9004GP+ME-HV User Manual

5.6.5

Port Policing

This page allows you to configure Policer settings for all switch ports.
Label
Port
Enable
Rate
Unti
Flow Control
5.6.6

Queue Policing

This page allows you to configure Queue Policer settings for all switch ports.
ORing Industrial Networking Corp
Depending on the DP level of the frame, the remapped
DSCP value is
Translation->Egress Remap DP0' table or from the 'DSCP
Translation->Egress Remap DP1' table.
Description
The port number for which the configuration below applies
Check to enable the policer for individual switch ports
Configures the rate of each policer. The default value is 500.
This value is restricted to 100 to 1000000 when the Unit is
kbps or fps, and is restricted to 1 to 3300 when the Unit is
Mbps or kfps.
Configures the unit of measurement for each policer rate as
kbps, Mbps, fps, or kfps. The default value is kbps.
If Flow Control is enabled and the port is in Flow Control
mode, then pause frames are sent instead of being
discarded.
RGS-R9004GP+ME User Manual
either taken from the 'DSCP
122