Christie DWU951 Service Manual page 69

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
Wiring
%HIRUH DWWDFKLQJ WKH (1*,1( DVVHPEO\
Check the wiring around the ENGINE assembly before attaching the ass'y unit for preparing.
Do not pass any wire
through the ribs.
$IWHU DWWDFKLQJ WKH (1*,1( DVVHPEO\
Wire &13(/ &1669 /$03 83 )$1 FDEOH &:& 02725 FDEOH &1%/ DQG &1%/ as below.
Connect LAMP1 UP FAN cable
and CWC MOTOR cable.
DC RELAY PCB
ED08 ED06
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
DC RELAY PCB
Pass the IRIS fan cable on
the duct side of the boss.
Fasten CNBL2 on the left side
gap and fasten the LAMP1
DOWN FAN cable on the right
side gap.
Pass CNPF1, CNPF2 and
CNLP1 through the rib.
Ballast holder
upper
Pass LAMP1 UP FAN cable
on the duct side of the boss
to avoid pinching with the
UPPER CASE.
9LHZ IURP IURQW VLGH
DMD PCB
LAMP2 UP FAN
67
Hold the LAMP1 DOWN FAN
cable between the bosses
temporarLOy.
Power unit
circuit case
20mm
Connect CNPEL.
CN3
Wire CNPEL along the groove on
POWER UNIT
the frame, and pass it through
COOLING
the cutout part. Make sure to
keep wires from the hashed line.
Connect CNBL2 and CNBL1.
E602
5mm
Power unit
circuit case
Tape LAMP2 DOWN
FAN cable (W=20mm).
E601
Page 67 / 118