Christie DWU951 Service Manual page 75

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
POWER UNIT2 BALLAST
Disassembling
1) Disconnect CNLP2 and CNBL2 from the POWER
UNIT2 BALLAST.
2) Remove a screw to detach the POWER UNIT2
BALLAST from the ballast holder.
3) Detach the insulating covers from POWER UNIT2
BALLAST.
NOTE
Remember to detach the partitions and re-use them
with new POWER UNIT2 BALLAST. The service
parts do not include the covers.
Assembling
1) Attach firmly the partitions on POWER UNIT2 BALLAST as below.
2) Put POWER UNIT2 BALLAST on the bottom ballast holder and screw down.
Partition
Wiring
Connect CNLP2, CNPF2 and CNBL2 and wire them as below.
CNLP2
Wire CNLP2 as shown
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
Partition
Partition
POWER POWER
UNIT2 UNIT2
BALLAST
Wire CNBL1 by passing it through this groove
POWER UNIT2 BALLAST
73
Partition
POWER UNIT2
BALLAST
ballast
holder
Clip the partition with the flap
Clip the partition with Clip the partition with
the flap the flap
Clip the partition with the flap
CNBL2 (5pin-6pin)
Be careful not to confuse
CNBL2 (5Pin-6Pin) with
CNBL1 (5Pin-5pin).
T3x12 black screw
Torque: 0.68 0.88N m
CNPF2
ATTENTION
Page 73 / 118