Christie DWU951 Service Manual page 58

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
Rear side of the MAIN PCB
Wire the cables in the area surrounded with yellow dotted line according to WKH following procedure.
1. Connect and style
CNPW1 and CNPW2.
Style CNPW1 as shown
DQG ¿ [ LW WR WKH KRRN
 &RQQHFW WKH RWKHU FDEOHV DQG FKHFN WKH IHUULWH FRUHV )L[ &1/''
Connect CNLDD. &RQQHFW 32:(5 (;+$867 )$1 FDEOH &15&5 &1.(< DQG &1/&'
)L[ &1/'' WR WKH KRRN
at the neck, right under
the ferrite core.
3. Style CNGD1 and check the wiring if no
wire is possiEly pinched with UPPER
CASE or any other parts.
Front side of the MAIN PCB
Wire the cables in the area surrounded with red
dotted line according to the following.
Twine CNNWP, CNSSH and CNAWD
around CNLED as shown below.
CNNWP
CNSSH
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
Connect CNPW1.
&KHFN LI D IHUULWH FRUH LV ¿ [HG WR HDFK FDEOH RI
&1/'' &1.(< DQG &1/&' ZLWK D FDEOH WLH
and all the cores turn the ties to the PCB.
LED PCB
Connect CNNWP, CNSSH, CNLED, 32:(5 ,17$.( )$1 FDEOH
CNAWD, CNACR and CNRCR.
CNAWD
CNLED
Add CNPW2 to the
hook as shown.
Style CNGD1
as shown.
Make sure no wire rests on
the top of the bosses to avoid
pinching with the UPPER CASE.
LED PCB
56
Connect CNPW2.
REMOTE-F PCB
Page 56 / 118