Christie DWU951 Service Manual page 30

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
Replacing the LAMP UNIT
$ ODPS KDV ¿QLWH SURGXFW OLIH 8VLQJ WKH ODPS IRU ORQJ SHULRGV RI WLPH FRXOG FDXVH WKH SLFWXUHV GDUNHU
or the color tone poor. Note that each lamp has a different lifetime, and some may burst or burn out
soon after you start using them. Preparation of a new lamp and early replacement are recommended.
1. Turn the projector off, and unplug the power cord. Allow the projector to cool for at least 45 minutes.
 /RRVHQ WKH VFUHZ PDUNHG E\ DUURZ RI WKH ODPS FRYHU DQG WKHQ VOLGH GRZQ DQG OLIW WKH ODPS
cover to remove it. The lamp cover is tied to a short wire to prevent from falling. Be careful not to
KLW RU JLYH VKRFN WR WKH FRYHU EHFDXVH D IDQ PRWRU LV DWWDFKHG WR LW
3
 /RRVHQ WKH  VFUHZV PDUNHG E\ DUURZ RI WKH ODPS DQG VORZO\ SXOO WKH ODPS RXW E\ WKH KDQGOHV
Don't loosen other screws at this time.
3, 4
LAMP2 UNIT
(on the left side)
Handles
 ,QVHUW WKH QHZ ODPS DQG UHWLJKWHQ ¿UPO\ WKH  VFUHZV RI WKH ODPS WKDW DUH ORRVHQHG LQ WKH
SUHYLRXV SURFHVV WR ORFN LW LQ SODFH
 :KLOH SXWWLQJ WKH LQWHUORFNLQJ SDUWV RI WKH ODPS FRYHU DQG WKH SURMHFWRU WRJHWKHU VOLGH WKH ODPS
FRYHU EDFN LQ SODFH 7KHQ ¿UPO\ IDVWHQ WKH VFUHZ RI WKH ODPS FRYHU ZKLOH SUHVVLQJ LW XS
6. Turn the projector on and reset the lamp time using the ADVANCED MENU.
(1) Press the MENU button to display a menu.
(2) Select as the following using the cursor button.
EASY MENU > ADVANCED MENU > SETUP > LAMP & FILTER
(3) Select LAMP-1 HOURS or LAMP-2 HOURS.
 3UHVV WKH EXWWRQ WR VHOHFW ³2.´ RQ WKH GLDORJ ,W SHUIRUPV UHVHWWLQJ WKH ODPS WLPH
NOTE:
‡ 3OHDVH UHVHW WKH ODPS WLPH RQO\ ZKHQ \RX KDYH UHSODFHG WKH ODPS IRU D VXLWDEOH LQGLFDWLRQ
about the lamp.
'R QRW WRXFK WKH LQWHULRU RI WKH SURMHFWRU ZKLOH WKH ODPS LV WDNHQ RXW
Handle the lamp cover with care because it is assembled with cooling fan.
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
Lamp cover
CAUTION
28
Handles
LAMP1 UNIT
(in the middle)
Page 28 / 118