Christie DWU951 Service Manual page 73

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
Ballast cover (BALLAST FAN)
Disassembling
1) Remove 4 screws to detach the ballast cover. Put away CNBL2 and BALLAST FAN cable from the
holes on the ballast cover carefully.
2) Remove the BALLAST FAN.
Assembling & wiring
1) Attach the BALLAST FAN in place.
2) Attach the ballast cover on the ballast holder. Wire CNBL2
and BALLAST FAN cable through the holes on the cover as
below.
3) Wire CNLP2, CNPF2, CNBL2 and BALLAST FAN cable as
below. Attach the ballast shield-R and screw down.
OK
Wire
CNPF2 on
CNLP2
Wire CNLP1 through this clamp
BALLAST
SHIELD-R
M3x8 silver screws
Torque: 0.68-0.88N m
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
Torque: 0.68-
0.88N m
[CAUTION]
Wire CNPF2 without folding near
the connector.
NG
CNLP1
Wire CNPF1/2
through this clamp
Wire CNPF1/2 and CNLP1
through this clamp
Ballast cover
BALLAST
FAN
T3x12
black
Ballast holder
screws
BALLAST
FAN
Wire CNBL2 through
this hole
Ballast
cover
Wire CNPF1 on the left side and CNPF2 on the
right side. And wire them under the shield metal
as below.
CNPF1
71
Air Flow
ATTENTION
Make sure the direction
Wire the BALLAST
FAN cable through
this hole
CNPF2
BALLAST
SHIELD-R
Page 71 / 118