Christie DWU951 Service Manual page 10

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
4-4 LENS SHIFT adjustment
When you replaced the ENGINE assembly
or MAIN PCB, make sure to carry out this
adjustment after re-assembling the projector.
LENS_C bar
(You do not have to care the numbers in this menu.)
Example 1
LENS_C >>EXE T:xxx
Example 2
LENS_C >>EXE T:168
Example 3
LENS_C >>EXE T:err
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
B:xxx L:xxx R:xxx NG
B:802 L:281 R:803 OK
B:823 L:306 R:778 NG
Adjustment procedure
1. Display the LENS_C bar with the
buttons in FACTORY MENU - OPTION. (Example
1)
2. Press the button to run automatic adjustment
program.
NOTE: During this adjustment, the lens
automatically moves vertically and horizontally.
3. The right-most cell is highlighted after the
DGMXVWPHQW ¿QLVKHG &KHFN WKH VWDWXV 2. RU 1*
displayed in the cell.
OK: The adjustment was successful. (Example 2)
NG: The adjustment was failed. Go to the next
step. (Example 3)
 &KHFN WKH IROORZLQJV $IWHU WKH FRQ¿UPDWLRQ RU
WKH UHZRUN FDUU\ RXW WKH DGMXVWPHQW DJDLQ
 +DUQHVVHV DUH ¿UPO\ FRQQHFWHG WR WKH
connectors EM00, EM01, EM04 and EJ20 on
the MAIN PCB.
- None of objects or wires is pinched between the
LENS SHIFT MECH and the lens.
NOTE: Find the cell in which "err" is displayed,
and read the left-most letter (T, B, L or R) in the
cell. It shows the area where the adjustment was
failed.
T: Between the top side frame of LENS SHIFT
MECH and lens body
B: Between the bottom side frame of LENS
SHIFT MECH and lens body
/ %HWZHHQ WKH DLU¿OWHUVLGH IUDPH RI /(16
SHIFT MECH and lens body
R: Between the lamp-side frame of LENS SHIFT
MECH and lens body
8
and
Page 8 / 118