Christie DWU951 Service Manual page 82

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
Assembling
1) Attach the BATTERY PCB and the battery
holder in place on the bottom case and screw
down.
2) Attach the POWER INTAKE FAN in place.
3) Wire the CNAC1/2 as shown.
4) Put the POWER UNIT COOLING in place and
screw down. Put the earthing terminal and
screw down.
Torque: 0.68-0.88Nm
T3x12 black
screws
5) Connect CNAC, CNAC1/2 and CNACR to the POWER UNIT COOLING and wire them as below. 5) Connect CNAC, CNAC1/2 and CNACR to the POWER UNIT COOLING and wire them as below.
6) Connect CNAWV to the AC WATCH PCB and wire it as below. 6) Connect CNAWV to the AC WATCH PCB and wire it as below.
7) Screw down the grounding wire of CNAC to the bottom case as below. 7) Screw down the grounding wire of CNAC to the bottom case as below
8) Put the AC holder and the AC shield in place and screw them down.
CNACR
[CAUTION]
Wire CNAC1/2 thUough
this cut out part.
Tie CNAC1 and CNAC2 with a
cable tie at 15 mm from the
edge of CNAC1 connector.
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
CNAC
CNAC2
CNAC1
Wire CNAC1/2
through these
clamps
Torque: 0.39-0.59N m
Screw
M4x8 silver
AC WATCH PCB
Wire CNAWV beneath the board
Wire CNAWV through this hole
Screw
M4x8 silver
Torque: 0.39-0.59N m
80
Wire CNAC1/2 as
this location
Wire CNAWV
through this groove
Earthing
terminal
CNAWV
CNAC
Page 80 / 118