Christie DWU951 Service Manual page 67

DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
POWER UNIT HOLDER
NOTE:
Remove the MAIN PCB block before disassembling the
POWER UNIT HOLDER.
Disassembling
Remove 2 screws, and pull the POWER UNIT HOLDER up.
Assembling
Put the POWER UNIT HOLDER on the POWER EXHAUST
Wiring
Wire the cable around POWER UNIT HOLDER
as below after attaching it.
the AC inlet socket. Make sure the direction of AC inlet as
illustrated.
Check if CNAWV
passes through this
slot without pinching.
Earth cable CNAC
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
POWER UNIT
HOLDER
AC holder
POWER UNIT
HOLDER
Pass CNAWV between the cable
CNAC and POWER UNIT HOLDER.
Fix the AC inlet
socket CNAC in
the direction as
shown on the right.
65
T3x12, black screw,
torque: 0.68~0.88N m
Power unit
circuit case
Page 65 / 118