Table of Contents
Advertisement
A
NEUVIDEO
RS-232 & Telnet Commands
COMMAND
HELP
?
GET FW VER
GET MODEL NAME
GET MODEL TYPE
SET FACTORY DEFAULT
SET SYSTEM REBOOT
GET MAC 1 ADDR
SET IP MODE N1
GET IP MODE
GET IPCONFIG
SET IPADDR N1
GET IPADDR
SET NETMASK N1
GET NETMASK
SET GATEWAY N1
GET GATEWAY
SET IN N1 NAME N2
GET IN N1 NAME
SET OUT A NAME N1
GET OUT A NAME
SET OUT A ROUTE N1
GET OUT A ROUTE
GET IN TYPE LIST
GET OUT TYPE LIST
SET OUT A MASK N1
DESCRIPTION OF PARAMETER
Show all available commands.
Show all available commands.
Show the unit's firmware version.
Show the unit's product type.
Turn unit's power on.
Reset the unit's IP configuration to the factory defaults.
Reboot the unit.
Show the unit's MAC address.
Set the IP address assignment mode.
Available values for N1:
STATIC [Static IP mode]
DHCP
[DHCP mode]
Show the current IP mode.
Show the current IP address details.
Set the static IP Address.
N1 = X.X.X.X
[X = 0 ~ 255]
Show the current IP address.
Set the netmask address.
N1 = X.X.X.X
[X = 0 ~ 255]
Show the current netmask.
Set the gateway address.
N1 = X.X.X.X
[X = 0 ~ 255]
Show the current gateway.
Set the name of input N1.
N1 = 1 ~ 2
[Input number]
N2 = {Name}
[16 characters max]
Show input N1's current name.
N1 = 1 ~ 2
[Input number]
Set the name of the output.
N1 = {Name}
[16 characters max]
Show the output's current name.
Switch the output routing source to input N1.
N1 = 1 ~ 2
[Input number]
Show the output's current routing source.
Show each input's video type.
Show the video type of the output.
Enable or disable the mask setting on output N1.
Available values for N1:
OFF
[Mask disabled]
ON
[Mask enabled]
NOTE: When an output is masked, all video, including the banner, will be blanked out.
14
RS-232 & Telnet Commands
Advertisement
Table of Contents
