Hdmi over hdbaset receiver w/ ir, rs-232, poh pse & lan receiver & 4k uhd+ hdmi/vga over hdbaset w/ signal event automation 1 gang wallplate switcher (28 pages)
TABLE OF CONTENTS CONTENTS DISCLAIMERS The information in this manual has been carefully checked and Introduction and Contents ............1 is believed to be accurate. We assume no responsibility for any Features ................2 infringements of patents or other rights of third parties which may result from its use.
October 2011. Any changes of functions and parameters since then will be informed separately. Please refer to the dealers for the latest details. This manual is copyright A-NeuVideo, inc. All rights reserved. No part of this publication may be copied or reproduced without the prior written consent of A-NeuVideo, Inc.
FEATURES ANI-MINI601HD is a presentation scaler switcher designed for multi-signal processing, signals of C-Video, S-Video, YPbPr, VGA and HDMI can be scaled to high-resolution HDMI format and switched out. The Audio is following video switching, all the audio is scaled to HDMI embedded digital audio, 3.5mm stereo audio and Coaxial(SPDIF) audio outputs.
FRONT AND REAR PANEL FRONT PANEL (1) Power indicating LED. It will stay red when the unit is connected to power. (2) USB input. While used to support fi rmware updates (provided under technical support from the factory) It can work as a USB fl...
VIDEO/AUDIO DESCRIPTION Below are the detailed descriptions of inputs and outputs. COMPOSITE VIDEO AND S-VIDEO INPUT Supports PAL/SECAM/NTSC Changeable aspect ratio. (Full-screen, wide screen, 4:3) Color RGB adjustable COMPONENT INPUT Input Display Parameter Resolution Frame Frame Frame Frequency Frequency Frequency 720x480I 15.75 720x480P...
OSD OPERATION (ON-SCREEN-DISPLAY) The ANI-MINI601HD provides an OSD operation menu, with various functions and languages supported. The functions supported are: PICTURE SETTING The fi rst icon from left of OSD menu is to set the picture parameter. It includes the pictures mode preset, color temperature, contrast, brightness, hue, saturation, sharpness, scale, VGA setting and Advance picture adjust.
Figure 5: OSD USB MP3 playback Figure 4: OSD USB Settings When you enter this page, you can select the fi le from USB fl ash disk, which is plugged to ANI-MINI601HD. You can use the up/down/ left/right buttons to control it.
CONTROLLING REMOTE OPERATION Select the video source, audio following switching Status setting for audio/video OSD operation, and volume control Select the output resolution...
RS-232 CABLE PINS USED 1. Transmission Rate: 9600 bps 2. Data Format: 8 data bits, No parity , 1 start bit, and 1 stop bit 3. Flowing Control: None Also known as 9600,8,n,1...
RS-232 PROTOCOL Note: 1: The letter inside the bracket [ ] is the variable code, which is changeable. 2: The bracket [ ] is not part of the command. 3: Any dot “.” after the letters is part of the command. Example 1: Switch the Input 2 to the line out.
Page 14
0636% Check sharpness Sharpness: XX 0639% Check the color temperature Color Temp: XX 0640% Check the fi rmware version ANI-MINI601HD V XXXXX 0699% OSD CHANNEL display enabled OSD Source: Display 0644% Shield OSD CHANNEL OSD Channel (Source): No Display 0645%...
The ANI-MINI601HD supports fi rmware fi eld-updating, by USB fl ash disk. 1. Copy the fi le “ANI-MINI601HD.bin” to a USB fl ash disk. (The “ANI-MINI601HD.bin” fi le is provided by A-NeuVideo engineering department) 2. Plug the USB fl ash disk to the ANI-MINI601HD USB port on the front panel.