A-Neuvideo ANI-H-KIT Instruction Manual page 14

A NEUVIDEO
System Settings Tab
set manually, or DHCP can be enabled for automatic IP Configuration if your local network supports it. Click on "Save" to confirm and
activate any changes made to these settings.
Note: If the IP address is changed then the IP address required for WebGUI and Telnet access will also change accordingly.
4. System:
• Reboot: Click this button to reboot the unit.
• Factory Default: Click this button to reset the unit to the factory default settings.
5. Firmware Upgrade: To update the unit's firmware, click the "Choose File" button to open the file selection window and then select
the firmware update file (*.bin format) located on your local PC. After selecting the file, click the "Upgrade" button to begin the firmware
update process. Once the process completes the unit will automatically reboot.
This tab provides access to control a number of system
configuration controls including displaying the unit's serial
number, modifying the web access privileges, changing the
IP configuration, performing a factory reset, rebooting the
system, and updating the firmware.
1. Serial Number: Displays the unit's serial number.
2. Web User Setting: This section provides a way to change
the password for the Administrator account. Click on "Save"
to confirm and activate any changes made to these settings.
NOTE: The default password is "admin".
3. Network: The IP Address, Netmask and Gateway can be
12
WebGUI Control