Table of Contents
Advertisement
A
NEUVIDEO
W ALLPLATE
FRONT PANEL
BACK PANEL
OPERATION CONTROLS & FUNCTIONS
FAC RESET Button:
Press and hold for 5 seconds to reset the unit to its factory
q
defaults.
SERV.:
This slot is reserved for firmware update use only.
w
NOTE: This USB port can provide up to 500mA to connected devices.
L/R IN:
Connect to the stereo analog output of a device such as an audio player
e
or PC for embedding into the HDBaseT
INFO Button:
A short press of this button will switch between the available inputs.
r
Pressing and holding this button for 2 seconds will activate the information OSD.
VGA IN:
Connect to VGA source equipment such as a PC or laptop.
t
HDCP LED:
This LED indicates the HDCP mode of the current input. Green
y
indicates Follow Display mode, orange indicates Follow Source mode, off indicates
HDCP is disabled.
SRC LED:
This LED indicates which source is currently selected. Green indicates
the HDMI input, orange indicates the VGA input.
PWR LED:
This LED will illuminate to indicate the unit's power and link status.
Orange indicates the unit is on and receiving power, green indicates the unit is on,
receiving power, and has successfully linked to a compatible Receiver.
HDMI IN:
Connect to HDMI source equipment such as a media player, game
u
console or set-top box.
CAT5e/6/7 OUT:
Connect to a compatible HDBaseT
q
CAT5e/6/7 cable for transmission of all data signals.
DC 12V:
Connect a 12V DC power adapter to the twin terminal block and connect
w
it to an AC wall outlet for power. (Optional, not required when powered by PoH from
the Receiver.)
5
output.
™
Receiver with a single
™
Advertisement
Table of Contents
