A-Neuvideo ANI-H-KIT Instruction Manual page 8

A NEUVIDEO
Receiver
STD/UPDATE:
This switch is reserved for factory use only.
q
RS-232 OUT: Connect to a serial controllable device for the extension of RS-232 signals.
w
LAN: Connect to an Ethernet device or to your local network as appropriate.
e
POWER LED: This LED will illuminate to indicate the unit is on and receiving power.
r
LINK LED: This LED will illuminate solid when both Transmitter and Receiver are connected and communicating with each other
t
properly.
DC 48V: Plug the 48V DC power adapter into this port and connect it to an AC wall outlet for power.
y
IR1 BLASTER: Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR Blaster in direct line-of-sight of the
u
equipment to be controlled.
IR2 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception. Ensure that remote being used is within the direct
i
line-of-sight of the IR Extender.
CAT5E/6/7 IN: Connect to a compatible HDBaseT
o
HDMI OUT:
Connect to an HDMI TV, monitor or amplifier for digital video and audio output.
a
OPERATION CONTROLS & FUNCTIONS
Transmitter with a single CAT5e/6/7 cable for transmission of all data signals.
™
6