A-Neuvideo ANI-H-KIT Instruction Manual page 17

A NEUVIDEO
COMMAND
GET OUT A MASK 
SET OUT AUTO MODE N1 
GET OUT AUTO MODE 
GET IN PORT NUMBER 
GET OUT PORT NUMBER 
GET IN N1 SYNC STATUS 
GET OUT A SYNC STATUS 
SET ALL IN EDID MODE N1 
GET ALL IN EDID MODE 
SET ALL IN EDID N1 
GET ALL IN EDID 
SET IN N1 EDID N2 
GET IN N1 EDID 
GET IN EDID LIST 
SET EDID N1 NAME N2 
DESCRIPTION OF PARAMETER
Display the current output mask setting.
Enable or disable automatic source switching.
Available values for N1:
0 [Auto switch disabled]
1 [Auto switch enabled]
Show the current auto switch mode state.
Show the number of inputs on the unit.
Show the number of outputs on the unit.
Show the current sync status of input N1.
N1 = 1 ~ 2 [Input number]
Available Responses:
0 [No sync]
1 [Sync is present]
Show the current sync status of the output.
Available Responses:
0 [No sync]
1 [Sync is active]
Enable or disable using the same EDID for all inputs.
Available values for N1:
ON [All mode]
OFF [Appoint mode]
Show the current state of the EDID assignment mode.
Set the EDID to use when set to "All mode".
Available values for N1:
1 [8-bit/1080p/2CH LPCM]
2 [8-bit/1080p/MCH]
3 [12-bit/4K@30/2CH LPCM]
4 [12-bit/4K@30/MCH]
5 [12-bit/4K@60/2CH LPCM]
Show the current "All mode" EDID.
Assign EDID N2 to input N1 in "Appoint mode".
N1 = 1 ~ 2 [Input number]
Available values for N1:
1 [8-bit/1080p/2CH LPCM]
2 [8-bit/1080p/MCH]
3 [12-bit/4K@30/2CH LPCM]
4 [12-bit/4K@30/MCH]
5 [12-bit/4K@60/2CH LPCM]
Show the EDID currently assigned to input N1.
N1 = 1 ~ 2 [Input number]
List all available EDID sources.
Set the name of User EDID N1 to N2.
N1 = 7 ~ 8 [EDID number]
N2 = {Name}
[16 characters max]
NOTE: Only User EDIDs can be renamed.
15
RS-232 & Telnet Commands
6 [12-bit/4K@60/MCH]
7 [User 1]
8 [User 2]
9 [Sink A]
6 [12-bit/4K@60/MCH]
7 [User 1]
8 [User 2]
9 [Sink A]