A-Neuvideo ANI-H-KIT Instruction Manual page 19

A NEUVIDEO
COMMAND
SET AUTOMATION EVENT N1 UART
WAIT N2 SEC 
GET AUTOMATION EVENT N1 UART
WAIT 
SET AUTOMATION EVENT N1 UART
COMMAND N2 
GET AUTOMATION EVENT N1 UART
COMMAND 
SET AUTOMATION EVENT N1 CEC N2 
GET AUTOMATION EVENT N1 CEC 
SET AUTOMATION EVENT N1 CEC
DELAY N2 SEC 
GET AUTOMATION EVENT N1 CEC
DELAY 
DESCRIPTION OF PARAMETER
Set the length of time to wait after an Automation Event's RS- 232 response has been
activated before ANY other Automation Event can be detected.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
N2 = 1 ~ 300 [Wait time in seconds]
NOTE: If both an RS-232 and CEC event is activated by the same Automation Event,
the longer of the 2 wait times will be used.
Show the wait time for the specified Automation Event's RS-232 response.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
Set the RS-232 command string to send when the specified Automation Event is
activated.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
N2 = {Command} [Max 32 characters]
Show the RS-232 command string to be sent when the specified Automation Event is
activated.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
Enable or disable the specified Automation Event's CEC response.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
Show the current state of the specified Automation Event's CEC response.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
Set the delay time that the specified Automation Event must continue to be true before
sending the defined CEC command.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
N2 = 1 ~ 300
[Delay in seconds]
Show the delay time for the specified Automation Event's CEC response.
Available values for N1:
1 [Power on]
2 [Out A source active]
3 [Out A source lost]
17
RS-232 & Telnet Commands
Available values for N2:
ON [Event enabled]
OFF [Event disabled]