Gauge Wheel - Landoll 2512 Series Operator's Manual

Coverboard Installation
1. Insert three 1/2-13 x 2-1/2 hex screws into the
coverboard bracket before attaching the coverboard
furrower (See Figure
and tighten only so that locking portion of nut
engages the thread. The customer will tighten these
nuts after mounting to shank.
2. Tighten the 7/16-14 flange nut to the 7/16-14 x 1-1/4
plow bolt before tightening the 1/2-13 hex nut to the
1/2-13 x 1-1/2 roundhead screw. This is to ensure
that the point of the coverboard furrower is pulled
tightly against the bracket. Make sure that the plow
bolt head is flush with the surface of the coverboard
furrower (See Figure
tightened now.
Figure 3-5: Coverboard Installation
TABLE OF CONTENTS
3-3.) Secure with 1/2-13 nuts
3-5.) This hardware should be
ASSEMBLY INSTRUCTIONS
Right Hand & Left Hand Coulter
Assemblies
1. Assemble coulter adjustment tube to coulter
assembly using roll pins 1/2 x 4 and 5/16 x 4.
Assemble the coulter stop to the coulter adjustment
tube using 1/2 x 4 screw and nut
2. Install the coulter adjustment tube and coulter
assembly to the frame using the coulter clamp tube,
4 u-bolts, clamp plate and 5/8-11 lock nuts. Do not
tighten nuts until the depth adjustment is completed.
3. Use adjustment pin and 3/16 hairpin to set desired
depth. Tighten 5/8 lock nuts on the u-bolts.
4. Attach coulter blade to coulter assembly using 1/2 x
1-1/2 screws and locknuts.

Gauge Wheel

1. The gauge wheel assembly comes fully assembled
from the factory.
2. Attach the tire and wheel assembly to the hub and
tighten the lug nuts to the proper torque as specified
in Figure 2-1.
(See Figure 3-6)
3-7