Gauge Wheel Installation; Hydraulic Lift Installation - Rigid And 15' Fold - Landoll Tilloll 875 Series Operator's Manual

Gauge Wheel Installation

1. All gauge wheel arms, rockshafts, and hubs come
already assembled from the factory.
2. Mount the tires on the wheels and install on the hubs.
3. Recommended tires: 11L X 15 10 ply
Hydraulic Lift Installation - Rigid
and 15' Fold
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Install stroke control and stroke control cover on
master cylinder(s), and parallel system cylinder on
15' fold model. Replace cylinder yoke(s). Adjust
cylinder extended length to measure 28-1/4" from
hole center to hole center. Tighten lock bolt or set
screw to lock yoke in place.
NOTE
Always adjust the slave cylinder extended length to
measure the same as the master cylinder to allow the
unit to operate level in the field.
ITEM PART NO.
A 1-397-010301114
1-397-010301194
B 1-397-010301238
1-397-010301284
C 162780
D 71508984
E 137602
F 1422176
G 117260
1/2 X 114 (875-10)
1/2 X 194 (875-13 & 875-15)
1/2 X 238 (875-10)
1/2 X 284 (875-13 & 875-15)
1/2 X 251 (875-15F)
3/8 X 42 (875-15F)
3/8 X 27 (875-15F)
3/8 X 116 (875-15F)
3/8 X 156 (875-15F)
Table 3-1: Hydraulic Hose Installation - Rigid and 15' Fold
ASSEMBLY INSTRUCTIONS
2. Install the master cylinders (all models) and slave
cylinder (rigid models) on the main frame ports up,
using clevis pin and cotter pins. Connect rod to
gauge wheel arm or rockshaft using extended pin
and 1/4 hair pins.
3. Install the non-series cylinder on the 15' fold model
on the main frame ports up, using clevis pin and
cotter pins. Connect rod to gauge wheel arm or
rockshaft using extended pin and 1/4 hair pins.
4. Install the slave cylinder on the 15' fold model on the
wing frame ports up, using clevis pin and cotter pins.
Connect rod to gauge wheel arm or rockshaft using
extended pin and 1/4 hair pins.
o
5. Install 90 adapters into base and rod end of each lift
cylinder.
6. Install hoses (See Figures 3-6 and 3-7 and
Table 3-1).
IMPORTANT
All cylinder ports are plugged. Do not forget to
remove all plugs and replace with hoses or fittings
before applying hydraulic pressure to cylinders.
HOSE LENGTH (MODEL USED)
3-9