Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
RSB Clamp and Straight Shank
Assembly
1. The rigid clamp assemblies are already located on
the frame at the proper spacing.
2. Attach wearstrip to straight leg shank using wearstrip
bracket, 3/4-10 x 3 hex head cap screw, and 3/4-10
hex lock nut
(See Figures
3-6
TABLE OF CONTENTS
3-4)
ROLL PIN GAPS
PLACED OPPOSITE
EACH OTHER
Figure 3-4: RSB Clamp and Straight Leg Shank Assembly
3. Attach steel point to low disturbance straight leg
shank using 1/2 x 2 and 5/16 x 2 spring slotted pins.
Place pins with open ends oriented opposite of each
other.
4. Attach top of shank point assembly to front of spring
clamp assembly using 3/4-10 x 4 hex head cap
screw and hex lock nut. Attach lower hole of shank
point assembly to rear of spring clamp assembly
using 5/8-11 x 5-1/2 hex head cap screw, connex
bushing, and 5/8-11 hex lock nut.
F-1040-0320
Advertisement
Table of Contents
