Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Assembly Preparation
1. Hook up the In-Row Ripper to a tractor using the
three-point hitch.
2.
Raise the unit about 36" and place stands under the
main frame to prevent accidental lowering.
WARNING
Do not attempt to lift heavy parts (such as the
frame), manually. Use a hoist or a forklift to move
these parts into position.
Jackstand Installation
1. Remove jackstand(s) from frame.
2. Remove rigid gauge adjustment pin and 3/16 hair pin
from outer jackstand tube.
3. Insert jackstand through bottom of outer jackstand
tube and pin at desired level with rigid gauge
adjustment pin and 3/16 hair pin
HYDRAULIC RESET CYLINDER
COULTER BLADES
3-2
TABLE OF CONTENTS
(See Figure
3-1.)
SMV EMBLEM
SMV BRACKET
Figure 3-1: 2512 Series Parts Identification
SMV Bracket Installation
1. Attach the SMV mounting bracket at a point where
emblem is visible from rear of machine, using u-bolt
and 5/8-11 flange head serrated nuts
Figure
3-1.)
2. Attach SMV emblem to top of SMV mounting bracket
using 1/4-20 x 1 hex head cap screws, flat washers,
and hex lock nuts
(See Figure
JACK STAND
(See
3-8.)
HYDRAULIC
ACCUMULATOR
ID PLATE
F-1040-0320
Advertisement
Table of Contents
