Front Gauge Wheels - Landoll 6250 Operator's Manual

Disc

Table of Contents

OPERATION AND MAINTENANCE

Front Gauge Wheels

1. The Disc is equipped with castering gauge wheels at

the outer front corners of each wing. These gauge

wheels are used to limit depth of the wings, and

prevent gouging and buckling of wing frames.

2. Gauge wheels are not intended to carry the wing, but

prevent excessive depth. Adjust the wheels to carry

some weight, but not enough to hold the wing from

reaching operating depth set with the main lift

hydraulics.

4-16

IMPORTANT

Excessive down pressure can cause the implement

to throw a center ridge.

3. To adjust the gauge wheel depth, loosen and adjust

the nuts on each side of the gauge wheel cross (See

Figure 4-19.) A wrench is provided on the

implement for this adjustment. All other connections

should remain tight. Securely tighten the adjusting

nuts when complete. Both gauge wheel assemblies

should be set the same. Verify adjustment by

measuring the length of the bolt centers of the gauge

wheel adjustment rod.