Fcc Compliance - Codan NGT 2010 RF Technical & Service Manual

FCC compliance

FCC Part 90 certification
The 2010 RF Unit with 2030 Junction Box and 2020 Handset complies with FCC
standards (FCC identifier code DYYNGT-3).
The 2011/2012 RF Unit with 2020 Handset complies with FCC standards (FCC
identifier code DYYNGT-11).
FCC Part 15 compliance
Any modifications made to the NGT series Transceiver (2010 RF Unit with 2030
Junction Box and 2020 Handset, or 2011/2012 RF Unit with 2020 Handset) and 3020
Transceiver Supply that are not approved by the party responsible for compliance may
void your equipment's compliance under Part 15 of the FCC rules.
The NGT series Transceiver (2010 RF Unit with 2030 Junction Box and 2020 Handset,
or 2011/2012 RF Unit with 2020 Handset) and 3020 Transceiver Supply have been
tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by switching the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
•
•
•
NGT Transceiver System Technical Service Manual
reorient or relocate the receiving antenna
increase the separation between the equipment and receiver
connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
consult the dealer or an experienced radio/TV technician for help
Compliance
23