Codan NGT 2010 RF Technical & Service Manual page 36

About this manual
Term
junction box
Master Bus mode
NGT remote
interface
PTT button
remote control
junction box
remote control
NGT system
RF unit
signalling rate
Slave Bus mode
throughput
transceiver
transceiver site
transmission
protocol
12
Means...
The unit in a transceiver to which a handset, 2010 RF Unit, speaker
and related devices are connected. The junction box receives the
instructions that a user enters through the handset and sends these
instruction to the relevant devices.
A CIB operating mode in which a CIB device, e.g. a 2010 RF Unit,
supplies power and TDM audio synchronisation pulses to the bus.
A device that converts CIB audio, control and status signals to and
from RS232 data to enable interfacing with a line modem.
The press-to-talk button, located on the left side of the handset.
This button enables you to communicate during voice calls, switch
mute off, cancel voice calls prior to the point where voice can be
transmitted, cancel calls where data is being transmitted, and exit
out of editable screens without saving changes.
A device that is used in a remote control system to interface with
other equipment including a modem or a radio/telephone
interconnect unit.
A fixed base station that consists of a control site and transceiver
site. The control and transceiver sites communicate via a modem at
each site. This enables the transceiver site to be located in an
electrically quiet area for more reliable transmission with less noise
interference.
The unit in a transceiver that modulates audio signals onto radio
frequencies that can be transmitted on air, and that demodulates the
radio frequencies it receives into audio signals.
The rate at which data is transmitted (this remains constant at
2400 bps).
A CIB operating mode in which a CIB device, e.g. a junction box,
sources its power supply and TDM audio synchronisation pulses
from the bus.
The average data transfer rate between stations (this varies with
different channel conditions).
The unit that modulates audio signals onto radio frequencies that
may be transmitted on air, and that demodulates the radio
frequencies it receives into audio signals. A transceiver comprises
an RF unit, handset, speaker, and appropriate connecting cables.
Transceivers that use a 2010 RF Unit also include a 2030 Junction
Box.
The location of the RF unit in a remote control NGT system. This
site is selected for its low electrical noise and good HF
propagation.
The method used by a modem to transmit and receive information.
NGT Transceiver System Technical Service Manual