Table of Contents
Advertisement
5.2
The CC-Link Interface
CC-Link gateway in IP65 can be connected to CC-Link with screw terminals inside
of the device. For that purpose the top of the housing has to be screwed off.
connection of CC-Link
interface on screw
terminal block
and arrangement on
circuit board:
The device in IP65 is powered out of the AS-i line to which it is connected by the
electromechanical interface (penetration technique as it is used with AS-i slaves).
5.3
Display and Operating Elements
On the front panel of the AS-i/CC-Link gateway are ten light-emitting diodes, a two-
digit display and two push buttons.
With the devices in IP65 the push buttons are situated inside of the housing to avo-
id liquids from entering. The top of the housing has to be screwed off to operate
these push buttons.
5.3.1
LEDs of the Single Masters
PW
L RUN
L ERR
SD
RD
CONF. ERR
AS-i
AS-I ACTIVE Normal operation active.
Subject to reasonable modifications due to technical advances.
14
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Connections, Displays and Operating Keys
1
2
3
4
5
6
7
8
9
10
The master's power supply is sufficient.
CC-Link Run LED
CC-Link interface communication active via the CC-Link interface.
CC-Link Error LED
A communication error occurs.
CC-Link Send Data LED
The CC-Link interface sends data.
CC-Link Receive Data LED
The CC-Link interface receives data.
Configuration error
At least one configured slave is missing, or at least one detected
slave is not projected or for at least one projected and detected
slave the actual configuration data does not match the nominal
configuration data.
The AS-i circuit is sufficiently powered.
FG
SLD
DG
DA
DB
Termination resistor:
FG
To be removed if module is
SLD
not at the end of line
DG
DA
DB
Copyright Pepperl+Fuchs, Printed in Germany
AS-Interface
Advertisement
Table of Contents
