Table of Contents
Advertisement
IPC6512-Z30&6522-Z30
User Guide
Step 2 Click
Step 3 Check Enable Video tampering checkbox to enable the video tampering detection.
Figure 8-44 Video Tampering Alarm
Step 4 Set the video tampering area; refer to
Configuring Motion
Step 5 Click
configuration is the same as the setting of the arming schedule for motion detection. Refer to
Task 2: Set the Arming Schedule for Motion Detection
Detection.
Step 6 Check the checkbox to select the linkage method taken for the video tampering. Audible warning,
notify surveillance center, send email and trigger alarm output are selectable. Please refer to
Task 3: Set the Alarm Actions for Motion Detection
Detection.
Step 7 Click
----End
8.7.3 Configuring Video Tampering Alarm
The exception type can be HDD full, HDD error, network disconnected, IP address conflicted
and illegal login to the domes.
Issue 02 (2014-12-25)
remove the default video tampering area.
Task1: Set the Motion Detection Area
Detection.
to edit the arming schedule for video tampering. The arming schedule
to save the settings.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Speed Dome Configuration
in
8.7.1 Configuring Motion
in
8.7.1 Configuring Motion
in
8.7.1
71
Advertisement
Table of Contents
