Table of Contents
Advertisement
IPC6512-Z30&6522-Z30
User Guide
Step 1 Enter the Text Overlay Settings interface: Configuration > Advanced Configuration > Image
> Text Overlay.
Figure 8-39 Text Overlay Settings
Step 2 Check the checkbox in front of textbox to enable the on-screen display.
Step 3 Input the characters in the textbox.
Step 4 Use the mouse to click and drag the red text frame in the live view window to adjust the text
overlay position.
Step 5 Click
----End
8.7 Configuring and Handling Alarms
This section explains how to configure the network dome to respond to alarm events, including
motion detection, external alarm input, video loss, video tampering and exception. These events
can trigger the alarm actions, such as Notify Surveillance Center, Send Email, Trigger Alarm
Output, etc.
For example, when an external alarm is triggered, the network dome sends a notification to an
e-mail address.
Issue 02 (2014-12-25)
NOTE
l Text Overlay cannot be displayed with PTZ OSD together. If you want to enable the Text Overlay
function, please disable the PTZ OSD first.
l When the speed dome is set as N system and 1080p resolution, only one text overlay is supported.
l It is recommended that the space between two text overlays should not be more than 4 lines, otherwise
there may be a position offset happening to the lower text overlay.
.
NOTE
l There are up to 4 text overlays configurable.
l If the video standard and resolution are selected as 60HZ and 1080p, only one text overlays is supported.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Speed Dome Configuration
67
Advertisement
Table of Contents
