Table of Contents
Advertisement
IPC6512-Z30&6522-Z30
User Guide
3.2 Mounting
3.2.1 Wiring
The survey of the actual installation environment and planning the wiring is highly recommended
before the accurate deployment of the wire is implemented in order to provide a safe and steady
power supply and a reasonable wiring route.
l
l
l
l
The wiring of the dome camera should be performed by professionals.
3.2.2 Wall Mount Installation
There are several ways to install the speed dome. In this guide, the non-thread wall mount
installation is taken as an example. Refer to the following steps for details:
Step 1 Get the wall mount and screws from the packing box as shown follows.
Figure 3-1 Wall Mount and Accessories
Step 2 Drill 4 φ12 screw holes in the wall according to the hole locations of the mount, and then insert
M8 expansion screws into the screw holes.
Issue 02 (2014-12-25)
Get familiar with the installation environment before deploying the wire, including the
wiring distance, surrounding, and electromagnetic interference and so on.
Please choose the cable with nominal voltage higher than the actual voltage, to ensure a
normal running in case of unsteady voltage.
To protect the power cable and the signal transmitting cable from human tampering, you
should pay attention to the protection and reinforcement of the cables.
When deploying the wire, please do not tighten the wire or make the wire loose.
NOTE
The speed dome can be installed to a thread interface or non-thread interface mount. The non-thread mount
is highly recommended.
When you select a thread mount, please install the pendent adapter(supplied) between the mount and speed
dome. Any mismatch problems shall be taken responsibility by the user.
The dimension of pendant adapter is G1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Installation
9
Advertisement
Table of Contents
