Table of Contents
Advertisement
IPC6512-Z30&6522-Z30
User Guide
Figure 3-2 Drill Screw Hole and Insert Expansion Screw
Step 3 Secure the wall mount with 4 hex nuts and washers.
Figure 3-3 Drill Screw Holes
----End
3.2.3 Speed Dome Installation
Before you start, please turn off the power of the speed dome before connecting the cables.
Step 1 Loosen the two lock screws as shown in the following figure.
Step 2 Remove the lower dome.
Issue 02 (2014-12-25)
NOTE
l For cement wall, you need to use the expansion screw to fix the mount.
l For wooden wall, you can just use the self-tapping screw to fix the mount.
l Please make sure that the wall is strong enough to withstand at least 8 times the weight of the dome
and the mount.
l The wall must be thick enough to mount the expansion screws.
NOTE
l Please remove the protective film on the lower dome after the installation is finished.
l Do not touch the bubble of the lower dome directly by hand. The image blurs otherwise.
l Remove the protective lens cover, foam and sticker from the dome drive.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Installation
10
Advertisement
Table of Contents
