How To Select A Display; Sd Cards - Furuno TZT9 Operator's Manual

1. SYSTEM INTRODUCTION
1.4

How to Select a Display

Use the Home key and the RotoKey
display selection window.
1. Press the Home key to show the display selection window.
2. Do one of the following.
• RotoKey
area at the bottom of the screen then push the key.
• Touch control: Select (tap) the required display.
1.5

SD Cards

The SD card stores the tracks, routes, points, settings, etc. Set and remove SD cards
as shown below. The Secure Digital Extended Capacity (SDXC) cards can also be
used.
How to format an SD card
You do not normally need to format an SD card for use with the system. If the card
becomes corrupted, format the card with a formatting program that is compatible with
the specifications of the SD card. The SD Memory Card Formatting Software made by
Panasonic is an example.
How to set an SD card
1) Pull the tab on the card drive cover to open the card drive.
2) As shown in the right figure, put the SD card in the right
card drive with the label right. If the card does not set eas-
ily, do not use force.
Note: The left card drive has a cover.
3) Push the card until the card is in position.
1-6
TM
TM
: Rotate the RotoKey
(or touch control) to select a display, from the
TM
to put the required display in the monitor
Monitor
area