Rack Mount Tpu Connections - Klein 4900 Series Operation And Maintenance Manual

NAV:
120/240 VAC:
12 VDC:
3.5.2

Rack Mount TPU Connections

All the connections to the Rack Mount TPU are made to connectors on the back
panel which is shown in Figure 3-2.
The Rack Mount TPU connectors are the following:
ETHERNET:
COM A:
COM B:
COM C:
NAV:
EXT TRIG IN:
T/F TRIG:
TRIG A:
1PPS IN:
TOWFISH:
AC INPUT:
Topside System Connections
DB9 male RS-232 serial port connector that
connects to a shipboard navigation system and
inputs NMEA 0183 message sentence formats. The
baud rate is 4800.
3-pin bulkhead connector that connects to an
88–264 VAC, 47–63 Hz power source.
4-pin bulkhead connector that connects to a 12 VDC
power source.
RJ-45 connector that connects to the ETHERNET
connector on the SonarPro Workstation.
DB9 male RS-232 serial port connector that is for
factory use only.
DB9 male connector that connects to a serial port of
the magnetometer control computer. The baud rate is
9600.
DB9 male RS-232 serial port connector that is
available as a spare and is not used.
DB9 male RS-232 serial port connector that
connects to a shipboard navigation system and
inputs NMEA 0183 message sentence formats.
Not supported for this system.
BNC connector that connects to an external sonar
system and is used to trigger the sonar of that system
at the start of each ping cycle. Provides a TTL
compatible, 1-msec wide output pulse.
BNC connector that connects to an ultra short
baseline navigation system (USBL). Provides a TTL
compatible, 1-msec wide output pulse with each
trigger of the optional responder.
BNC connector that connects a GPS and is used to
input 1 PPS (one pulse per second) signals.
Type N coaxial connector that connects to the
towfish or to the slip rings of the optional winch.
IEC type connector that connects to the AC power
source.
3-7