Sonarpro Workstation Controls And Indicators; System Activation And Test; Activating And Testing The System On Deck - Klein 4900 Series Operation And Maintenance Manual

3-18
CHAPTER 3 Setup and Test
3.7.3
Most of the SonarPro Workstation controls and indicators are on the SonarPro
Workstation front panel which is shown is Figure 3-5. Also shown is the location
of the DVDRW optical drive.
The SonarPro Workstation controls and indicators are the following:
ON/OFF switch:
HARD DRIVE ACTIVITY:
ETHERNET:
POWER:
POWER switch:
RESET switch:
3.8

System Activation and Test

The Series 4900 Sonar System should be activated and tested on deck and at sea
before starting an actual survey.
3.8.1
To activate and test the system on deck:
1. Verify that the towfish has been properly set up and the system components
connected.
2. Turn on the navigation system and let it acquire its location.
Series 4900 Sonar System Operations and Maintenance Manual

SonarPro Workstation Controls and Indicators

Rocker switch/circuit breaker that switches AC
power to the SonarPro Workstation and provides AC
input current protection. This switch/circuit breaker,
which is on the back panel and is shown in
Figure 3-3 on page 3-10, should be left in the ON
position. Should the breaker trip, the switch/circuit
breaker will switch to the OFF position. To reset it,
switch it to the ON position.
Green LED that flashes when the hard drive is being
accessed.
Green LED that flashes when there is activity on
Ethernet port.
Blue LED that is on when the SonarPro Workstation
is on.
Push button switch that turns the SonarPro
Workstation on or off.
Push button switch that resets the SonarPro
Workstation.
NOTE Should it be required to change the IP address, edit the startup.ini
file or update the software of the SP-III TPU, refer to APPENDIX B:
"Configuring and Updating the SP-III TPU"

Activating and Testing the System on Deck

P/N 11210091, Rev. 02