Aligning The Locking Screws Before Inserting The Forward End Cap; Aligning The Locator Pin In The Nose Cone With The Slot In The Towfish Housing - Klein 4900 Series Operation And Maintenance Manual

4-10
CHAPTER 4 Equipment Maintenance
11. Slide the nose cone into the
towfish housing, aligning
the locator pin on the nose
cone with the slot in the
housing and threading the
nose cone retaining bolt
into the forward end cap as
shown in Figure 4-14.
12. Tighten the nose cone
retaining bolt.
Series 4900 Sonar System Operations and Maintenance Manual
Figure 4-13:
Aligning the Locking Screws
before Inserting the Forward End Cap
Figure 4-14:
Aligning the Locator Pin in the
Nose Cone with the Slot in the Towfish Housing
Slot
Locator pin
P/N 11210091, Rev. 02