Assembly; Location Of The Four Socket Head Cap Screws On The Face Of A Transducer; Removing The Eight Phillips Head Screws Securing The Transducer - Klein 4900 Series Operation And Maintenance Manual

4-12
CHAPTER 4 Equipment Maintenance
Set the transducer assembly
4.
down with the transducer
facing up.
5. Using the 4-mm hex key,
remove the four socket
head cap screws on the face
of the transducer, two on
each end.
6. Turn the transducer
assembly over, and using
the Phillips head
screwdriver, remove the
eight screws securing the
transducer to the transducer

assembly.

7. Separate the transducer
from the transducer
assembly.
8. Repeat Steps 2 through 7 to
remove the other
transducer.
Series 4900 Sonar System Operations and Maintenance Manual
Socket head
cap screw
(2 each end)
Figure 4-17:
Location of the Four Socket Head
Cap Screws on the face of a Transducer
Figure 4-18:
Removing the Eight Phillips Head
Screws Securing the Transducer
P/N 11210091, Rev. 02