Frame descriptions
Remote Command Response frame - 0x97
Description
If a device receives this frame in response to a Remote Command Request (0x17) frame, the device
sends an AT Command Response (0x97) frame out the serial interface.
Some commands, such as the ND command, may send back multiple frames. For details on the
behavior of ND, see
Format
The following table provides the contents of the frame. For details on frame structure, see
format.
Frame data fields
Frame type
Frame ID
64-bit source (remote)
address
16-bit source (remote)
address
AT commands
Command status
Command data
Extended Modem Status frame - 0x98
Description
The Extended Modem Status frame (0x98) is intended to provide additional in-frame diagnostic
information over the traditional Modem Status (0x8A) frame. The extended modem status frames
must be enabled for specific operations.
Note
This option is provided for diagnostic purposes.
Digi XBee® 3 802.15.4 RF Module User Guide
ND (Network
Discover).
Offset Description
3
0x97
This is the same value that is passed into the request.
4
The request is a 0x17 frame.
5-12
The long address of the remote device returning this
response.
13 -
The short address of the remote device returning this
14
response.
The name of the command.
15-16
0 = OK
17
1 = ERROR
2 = Invalid Command
3 = Invalid Parameter
4 = Remote Command Transmission Failed
0x0B = No Secure Session Connection
0x0C = Encryption Error
0x0D = TO Bit Not Set
18-n
The value of the requested register in hexadecimal notation
(non-ASCII).
Remote Command Response frame - 0x97
API frame
229