Command Mode Options; Cc (Command Character); Ct (Command Mode Timeout); Gt (Guard Times) - Digi XBee 3802.15.4 User Manual

AT commands
Default
0

Command mode options

The following commands affect how

CC (Command Character)

The character value the device uses to enter Command mode.
The default value (0x2B) is the ASCII code for the plus (+) character. You must enter it three times
within the guard time to enter Command mode. To enter Command mode, there is also a required
period of silence before and after the command sequence characters of the Command mode
sequence (GT + CC + GT). The period of silence prevents inadvertently entering Command mode. For
more information, see
Parameter range
0 - 0xFF
Default
0x2B (the ASCII plus character: +)

CT (Command Mode Timeout)

Sets or displays the Command mode timeout parameter. If a device does not receive any valid
commands within this time period, it returns to Idle mode from Command mode.
Parameter range
2 - 0x1770 (x 100 ms)
Default
0x64 (10 seconds)

GT (Guard Times)

Set the required period of silence before and after the command sequence characters of the
Command mode sequence, GT + CC + GT (including spaces). The period of silence prevents
inadvertently entering Command mode. For more information, see
Parameter range
0x2 - 0x6D3 (x 1 ms)
Default
0x3E8 (one second)

CN (Exit Command mode)

Executable command. CN immediately exits Command mode and applies pending changes.
Parameter range
N/A
Digi XBee® 3 802.15.4 RF Module User Guide
Command mode
Enter Command mode.
Command mode options
operates.
Enter Command mode.
151